Miller cycle
|
|
Template:Reqimage In engineering, the Miller cycle is a combustion process used in a type of four-stroke internal combustion engine. The Miller cycle was patented by Ralph Miller, an American engineer, in the 1940s. This type of engine was first used in ships and stationary power-generating plant, but has recently (late 1990s) been adapted by Mazda for use in their Millenia large sedan.
The traditional Otto cycle used four "strokes", of which two can be considered "high power" – the compression and power strokes. Much of the power lost in an engine is due to the energy needed to compress the charge during the compression stroke, so systems to reduce this can lead to greater efficiency.
In the Miller cycle the intake valve is left open longer than it normally would be. This is the "fifth" cycle that the Miller cycle introduces. As the piston moves back up in what is normally the compression stroke, the charge is being pushed back out the normally closed valve. Typically this would lead to losing some of the needed charge, but in the Miller cycle the piston in fact is over-fed with charge from a supercharger, so blowing a bit back out is entirely planned. The supercharger typically will need to be of the positive displacement kind (due its ability to produce boost at relatively low RPM) otherwise low-rpm torque will suffer.
The key is that the valve only closes, and compression stroke actually starts, when the piston has pushed out this "extra" charge, say 20% to 30% of the overall motion of the piston. In other words the compression stroke is only 70% to 80% as long as the physical motion of the piston. The piston gets all the compression for 70% of the work.
The Miller cycle "works" as long as the supercharger can compress the charge for less energy than the piston. In general this is not the case, at higher amounts of compression the piston is much better at it. The key, however, is that at low amounts of compression the supercharger is more efficient than the piston. Thus the Miller cycle uses the supercharger for the portion of the compression where it is best, and the piston for the portion where it is best. All in all this leads to a reduction in the power needed to run the engine by 10% to 15%. To this end successful production versions of this cycle have typically used variable valve timing to "switch on & off" the Miller cycle when efficiency does not meet expectation.
In a typical Spark Ignition Engine however the Miller cycle yields another benefit. Compression of air by the supercharger and cooled by an intercooler will yield a lower intake charge temperature than that obtained by a higher compression. This allows ignition timing to be altered to beyond what is normally allowed before the onset of detonation, thus increasing the overall efficiency still further.
A similar delayed valve closing is used in some modern versions of Atkinson cycle engines, but without the supercharging.