Black start
|
|
Restoring power after a wide-area power outage can be difficult, as power stations need to be brought back on-line. Normally, this is done with the help of power from the rest of the grid. In the absence of grid power, a so-called black start needs to be performed to bootstrap the power grid into operation.
To provide a black start, some power stations are typically equipped with small diesel generators which can be used to start larger generators (of several megawatts capacity), which in turn can be used to start the main power station generators. Generating plants using steam turbines require station service power of up to 10% of their capacity for boiler feedwater pumps, boiler forced-draft combustion air blowers, and for fuel preparation. It is uneconomic to provide such a large standby capacity at each station, so black-start power must be provided over the electrical transmission network from other stations.
A typical sequence (based on a real scenario) might be as follows:
- A battery starts a small diesel generator installed in a hydroelectric generating station.
- The power from the diesel generator is used to bring the hydroelectric generating station into operation.
- Key transmission lines between the hydro station and other areas are energized.
- The power from the hydro dam is used to start one of the coal-fired base load plants.
- The power from the base load plant is used to restart all of the other power plants in the system including the nuclear power plants.
- Power is finally re-applied to the general electricity distribution network and sent to the consumers.
External links
- An article by a commercial supplier of black start equipment (http://www.wartsila.com/english/pdf/power_plants/en14_articles/blackstart_essential_for_powerplant_security.pdf)