Panel dividing equipment
|
|
Panel dividing equipment is a kind of woodworking machinery (panel line) that is intended to divide master panel into sized parts.
- Automatic 2-D system
- Similar to High speed panel saw with lifting table (1-D, rip cut), but extra with 2nd Beam saw unit (2-D, cross cut).
- Commercial name: Angular system.
- Similar to High speed panel saw with lifting table (1-D, rip cut), but extra with 2nd Beam saw unit (2-D, cross cut).
- Automatic 1-D system
- Similar to High speed panel saw but extra with automatic loading system, called lifting table or rear loading device.
- Commercial name: High speed panel saw with lifting table
- Commercial name: High speed panel saw with rear loading device
- Similar to High speed panel saw but extra with automatic loading system, called lifting table or rear loading device.
- Panel saw also known as Beam saw
- Saw carriage speed >= 100M/Min
- Commercial name: High speed panel saw
- Typical: Saw blade projection 140mm, Saw carriage speed 120M/Min, NC gripper speed 100M/Min.
- Typical: Saw blade projection 125mm, Saw carriage speed 100M/Min, NC gripper speed 50M/Min.
- Saw carriage speed < 100M/Min.
- Commercial name: Panel saw or Low speed panel saw
- Typical: Saw blade projection 95mm, Saw carriage speed 80M/Min, NC gripper speed 40M/Min.
- Typical: Saw blade projection 70mm, Saw carriage speed 60M/Min, NC gripper speed 30M/Min.
- Saw carriage speed >= 100M/Min
- Panel saw without NC gripper or Panel saw without NC fence
- Commercial name: Manual panel saw or Manual beam saw
- Typical: Saw blade projection 70mm, Saw carriage speed 30M/Min.
- Sliding table saw manual operation
- Typical: Saw blade projection 60mm.