Rotary dial
|
|
The rotary dial is a device mounted on or in a telephone or switchboard that is designed to send interrupted electrical pulses, known as pulse dialing, corresponding to the number dialled. It was invented in 1888 by Almon Strowger.
04c093_rotary_dial_abc.jpg
Telephone No. 710
The dial is circular, about 78 mm (3 inches) in diameter, with 10 finger holes cut through the outer perimeter. The dial is mounted via a shaft extending from inside the phone or mounting and sits approximately 6 mm (¼ inch) above a faceplate. The faceplate is set so that through each finger hole letters and numbers printed on the faceplate may be seen. In North America, traditional dials have letter codes displayed with the numbers under the finger holes in the following pattern: 1, 2 ABC, 3 DEF, 4 GHI, 5 JKL, 6 MNO, 7 PRS, 8 TUV, 9 WXY and 0 Operator. However, such letter codes were not used in all countries. The illustration shows a UK dial. Older Australian rotary dial phones had them, but the letter combinations were often printed in the centre plate adjacent to the number. The 1 is normally set at approximately 60 degrees clockwise from the uppermost point of the dial (if one imagines an analogue clock face over the dial, the 1 is located at approximately the 2 o'clock position), and then the numbers progress upward counterclockwise, with the 0 being at about 5 o'clock. A curved device called a finger stop sits above the dial at the 4 o'clock position. To dial a 6, the user puts a finger in the 6 finger hole and rotates the dial clockwise until it reaches the finger stop. The user then pulls out the finger, and a spring in the dial returns it to the resting position. As the dial returns, electrical contacts wired through the mechanism underneath will open and close 6 times, thus sending 6 pulses to the receiving end. A centrifugal governor regulates the speed at which the dial returns under the force of the spring.
Many phone lines no longer recogonize pulse dialing, however, and it often has to be ordered separately from a phone company. The shorter dialing times possible for tone dialing added to the shift away from pulse dialing, which is has been largely abandoned in many places now.
Different pulse systems are used depending on which country you are in. Sweden uses 1 pulse to signal the number zero, and 10 pulses to signal the number nine. New Zealand uses ten pulses minus the number desired; so to dial 7, the hook must be pressed three times. In Norway, the North American system with the number 1 corresponding to one pulse was used, except from the capital, Oslo, which used the same "inverse" system as in New Zealand. For this reason, the numbers on the dial are shifted in different countries, or even in different areas of one country, to work with their system because of the difference of the number arrangement on the dial.
Note: Not all phone systems and phones support this method.
Tapping
You can trick a phone system into thinking you are using a rotary dial. To do this, find the little button, switch, or hook that is pushed down when you hang up the phone. To "dial" the digit 1, tap it once. For the digit 2, tap it twice QUICKLY (ten taps per second for UK phones - faster in North America). For the digit 3, use three taps, etc. The digit 0 is ten taps. (But see above if you are in Sweden, New Zealand or Oslo.) Some models of keypad phones have a tone/pulse switch. This is an easier way to dial pulse, but considered a less fun technique.
In the UK it used to be possible to make calls for free from coin-box phones (payphones) by tapping. This was on phones with A and B button boxes (http://web.ukonline.co.uk/freshwater/ccbpr.htm). (These were phased out between 1958 and 1979 as subscriber trunk dialling was introduced.) A person caught tapping would be charged with 'stealing electricity from the GPO'.